Removing the protective film

The protective film covers the front of Bell 2 and has a pull tab. Peel it off slowly, with dry, clean fingers. Do not use a knife or anything sharp, since the body is plastic and scratches easily.

Remove the film

1. Put the clock face up on a flat, soft surface such as a towel
2. Find the pull tab on the film
3. Hold the tab between your fingers
4. Pull the film back slowly and flat, close to the surface
5. Wipe off any fingerprints with a clean, dry cloth

Good to know

• Do not press on the knobs at the back while you work, and set the clock down upright afterwards.
• Clean Bell 2 with a clean, dry cloth only. Harsh cleaning products can stain the plastic.
• If the film leaves marks, a dry microfibre cloth usually removes them. Do not use solvents.